#IJSRD CFD Simulation of Compact Type Mini Channel Heat Exchanger by Using of Water
CFD Simulation of Compact Type Mini Channel Heat Exchanger by Using of Water
Abstract—A heat exchanger is a device that is used to transfer thermal energy (enthalpy) between two or more fluids, between a solid surface and a fluid, or between solid particulates and a fluid, at different temperatures and in thermal contact. In the conventional heat exchangers, pipes are larger in size which makes heat exchanger bulky. But in some typical applications such as closed loop gas turbine heat exchangers, cryogenic applications, heat exchangers used in PWR power plants, nuclear submarines, etc., size and weight are critical design constraints on the heat exchanger. Also for high pressure applications tubes are subjected to high bending stresses. To overcome these difficulties, compact heat exchangers can be employed. Mini channels heat exchanger is a type of compact heat exchanger in which mini channels are machined on metal plates and then such plates are bonded together. Such an arrangement provides high strength so that it can be used for high pressure applications. It has been observed that in mini channels, convective heat transfer coefficient is more than the tubes used in conventional heat exchangers. Hence, the length for same heat transfer is greatly reduced which results in reduced overall size and weight of the heat exchanger. Electronic device are in heavy demand for computer processor applications and generate large amount of heat. These high power device can be cooled off very effectively by either liquid or gas coolant flowing through micro or mini channels. Continuous research work is ongoing for developing high speed processor which generate high amount of heat. Cooling of such particular systems requires high amount of mass flow rate and compactness is also required. In present work, a mini channel heat exchanger is designed with assuming inlet and outlet of hot temperature, inlet of cold water temperature and also the mass flow rates of cold and hot water. This compact heat exchanger can be used for cooling purpose of electronics device like silicon chip which would be used for microprocessor. In order to cool down silicon chip, it is kept in place of hot fluid plate. Cooling of silicon chip is required to prevent from damage and subsequently failure. The heat exchanger is designed for obtaining 10°C of hot fluid.
For More Details Click on Below LInks :
Posted on August 19, 2014, in Uncategorized and tagged call for paper, call for research paper, e- Journal, IJSRD, Indian Journal, International Journal, Journal, Journal for Scientific Research & Development, journal of engineering, journal of Science, online Journal, peer reviewed journals, thesis publication. Bookmark the permalink. 1 Comment.